Remove the eight screws and then remove the rear cover. Press the Enter key. Due to this, the thickness of the laptop is reduced to All the devices are aimed at operation at the 1. Pull up the conveying cover lock lever on the Conveying cover left side of the printer, and open the conveying cover. Detects a paper misfeed in the switchback section in a duplex print. Insert a flat-blade screwdriver or the like into the clearance and remove the operation Operator panel cover panel cover.

Uploader: Dilrajas
Date Added: 7 September 2016
File Size: 17.88 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 5015
Price: Free* [*Free Regsitration Required]

Connect the other end of the power cord into a power outlet. Purpose To check the fixing temperature, the kz temperature and the absolute humidity. Defective fuser heater S. Check the status feedshift section is and remedy if necessary.

Placing the proper location. Dirty main charger wire. Primary feed conveys paper from the upper cassette, lower cassette or MP tray to the left and right registration rollers, at which point secondary feed takes place and the paper travels to the transfer section in sync with the printing timing. Memory gs-9520dn slot Figure 3.


In duplex printing, fs-9520dnn is turned over by reverse rotation of the eject motor. Page 37 Bit 0: Push the drum separation claw assemblies with the minus driver from the top of the corner hole and remove the claw assemblies. Primary paper feed from the upper cassette. Connecting the printer to the computer.

FSDN Driver Download Center | ServiceWorld | KYOCERA Document Solutions

Remove the seal from the rear of the old waste toner box, and then close the opening of the box with the seal. Insert the memory card into the printer’s memory card slot. MP paper feed shaft Caution: System firmware file name example B10K Also check for continuity within the con- The message re- paper switch connector nector cable.

Grid cleaner Figure Kc primary paper feed.


Page At the same time, feed clutch 1 FCL1 turns on for 30 ms. Run maintenance item U and turn the eject switch on and off The eject motor manually.


If the drum is flawed, replace the drum unit. Slot cover Figure 2. Enter the maintenance mode and press the key to display “U”. Seal up the old waste toner box with the supplied plastic bag and dispose it.


Remove the fuser unit see page No affiliation or endorsement is intended or implied. Installing the toner container. Purpose To check the connection status of each optional equipment. No developing bias is output.

Download Center

To remove paper jammed in the printer, open the front cover, conveying cover, side cover or cassette. Collimates the diffused laser beam emitted from the laser diode to convert it into a cylindrical beam.

A paper jam in the PF is extremely curled. Enter text from picture: Detects a paper misfeed in the fuser section. Check kylcera paper storage conditions.